Sains
Malaysiana 49(5)(2020): 1201-1208
http://dx.doi.org/10.17576/jsm-2020-4905-25
G-Jitter Fully Developed
Heat and Mass Transfer by Mixed Convection Flow between Two Parallel Plates
with Constant Heat Flux
(Ketar-G Pemindahan Haba Terbentuk Penuh oleh Aliran Olakan Campuran
antara Dua Plat Selari dengan Fluks Haba Tetap)
WAN NOR ZALEHA AMIN1, AHMAD QUSHAIRI MOHAMMAD1, SHARIDAN SHAFIE1* & MUHAMMAD QASIM2
1Department of Mathematical Sciences, Faculty of
Science, Universiti Teknologi Malaysia
81310 UTM Johor Bahru, Johor Darul Takzim, Malaysia
2COMSATS
University Islamabad, Park Road, Tarlai Kalan, 455000 Islamabad, Pakistan
Received: 27 February
2019/Accepted: 16 January 2020
ABSTRACT
In this research,
the problem of heat and mass transfer in mixed convection flow induced by
g-jitter is studied analytically. The flow passes through an infinite length of
vertical parallel plates. The left wall of the plate is prescribed with
constant heat flux while the right wall is maintained at a constant
temperature. The governing boundary layer equations are transformed into
dimensionless equations by using the appropriate dimensionless variables. The
behaviors of the velocity, temperature, and
concentration profiles of the fluid are analyzed by Fourier method and
illustrated graphically as well. Results show that due to an increase in value
of wall temperature, the fluid temperature increases. It is found that the
controlling parameters strongly affect the heat and mass transfer
characteristics in g-jitter fluid flow.
Keywords: Constant
heat flux; g-jitter; mixed convection; two vertical plates
ABSTRAK
Dalam kajian ini,
masalah bagi aliran pemindahan haba dan jisim di dalam aliran olakan campuran
yang disebabkan oleh ketar-g dikaji secara analitik. Aliran ini melepasi satu
plat selari menegak yang panjangnya tidak terhingga. Dinding sebelah kiri plat
ditetapkan dengan fluks haba tetap manakala dinding sebelah kanan pula
dikekalkan pada suhu tetap. Persamaan menakluk bagi lapisan sempadan diubah ke dalam
persamaan tak bermatra dengan menggunakan pemboleh ubah tak bermatra yang
bersesuaian. Telatah bagi profil halaju, suhu dan kepekatan bendalir dianalisis
dengan kaedah Fourier dan juga diilustrasi secara bergraf. Keputusan
menunjukkan bahawa dengan peningkatan nilai suhu dinding, suhu cecair juga
meningkat. Didapati bahawa parameter pengawal sangat mempengaruhi ciri pemindahan haba dan jisim dalam aliran
bendalir ketar-g.
Kata kunci: Dua plat menegak; fluks haba tetap; ketar-g; olakan campuran
REFERENCES
Altunkaya, A.N., Avci, M. & Aydin, O. 2017.
Effects of viscous dissipation on mixed convection in a vertical parallel-plate
microchannel with asymmetric uniform wall heat fluxes: The slip regime. International Journal of Heat and Mass
Transfer 111: 495-499.
Bakar,
N.A., Roslan, R., Karimipour, A. & Hashim, I. 2019. Mixed convection in
lid-driven cavity with inclined magnetic field. Sains Malaysiana 48(2):
451-471.
Chen,
Y.C. 2004. Non-Darcy flow stability of mixed convection in a vertical channel
filled with a porous medium. International
Journal of Heat and Mass Transfer 47(6-7):
1257-1266.
Chen,
Y.C., Chung, J.N., Wu, C.S. & Lue, Y.F. 2000. Non-Darcy mixed convection in
a vertical channel filled with a porous medium. International Journal of Heat and Mass Transfer 43(13): 2421-2429.
Hammou,
Z.A., Benhamou, B., Galanis, N. & Orfi, J. 2004. Laminar mixed convection
of humid air in a vertical channel with evaporation or condensation at the
wall. International Journal of Thermal
Sciences 43(6): 531-539.
Kamal,
F., Zaimi, K., Ishak, A. & Pop, I. 2019. Stability analysis of MHD
stagnation-point flow towards a permeable stretching/shrinking sheet in a
nanofluid with chemical reactions effect. Sains
Malaysiana 48(1): 243-250.
Kumar,
J.P., Umavathi, J.C., Pop, I. & Biradar, B.M. 2009. Fully developed mixed
convection flow in a vertical channel containing porous and fluid layer with
isothermal or isoflux boundaries. Transport
in Porous Media 80(1):
117-135.
Kumari,
M. & Nath, G. 2004. Mixed convection boundary layer flow over a thin
vertical cylinder with localized injection/suction and cooling/heating. International Journal of Heat and Mass
Transfer 47(5): 969-976.
Lee,
J.S., Xu, X. & Pletcher, R.H. 2004. Large eddy simulation of heated
vertical annular pipe flow in fully developed turbulent mixed convection. International Journal of Heat and Mass
Transfer 47(3): 437-446.
Mahat,
R., Rawi, N.A., Kasim, A.R.M. & Shafie, S. 2017. Mixed convection boundary layer flow of viscoelastic nanofluid past a
horizontal circular cylinder: Case of constant heat flux. Paper presented at the Journal of
Physics: Conference Series.
Naser,
N., Kasim, A.R.M. & Aurangzaib, S.S. 2013. G-Jitter mixed convection on
double diffusion adjacent to a vertical stretching sheet. Recent Advances in Mathematics 7: 174-181.
Rajvanshi,
S.C. & Saini, B.S. 2010. Free convection MHD flow past a moving vertical
porous surface with gravity modulation at constant heat flux. International Journal of Theoretical and
Applied Sciences 2(1):
29-33.
Rawi,
N.A., Ilias, M.R., Jiann, L.Y., Isa, Z.M. & Shafie, S. 2018. The effect of
copper nanoparticles on mixed convection flow of jeffrey fluid induced by
g-jitter. Journal of Nanofluids 7(1): 156-162.
Rawi, N.A., Ilias, M.R., Isa, Z.M. & Shafie, S.
2017a. Effect of gravity modulation on mixed convection flow of second grade
fluid with different shapes of nanoparticles. Malaysian Journal of Fundamental and Applied Sciences 13(2): 132-136.
Rawi,
N.A., Kasim, A.R.M., Isa, Z.M., Mangi, A. & Shafie, S. 2017b. G-jitter
effects on the mixed convection flow of nanofluid past an inclined stretching
sheet. Frontiers in Heat and Mass
Transfer 8: e99384.
Rawi,
N.A., Amin, W.N.Z., Admon, M.A. & Shafie, S. 2017c. G-jitter fully developed heat transfer by
mixed convection flow of nanofluid in a vertical channel. Malaysian Journal of Fundamental and Applied Sciences 13(3). DOI:
https://doi.org/10.11113/mjfas.v16n1.1385.
Rosas, I.Y., Treviño, C. & Martínez-Suástegui, L.
2017. Experimental study of mixed convection heat transfer in a vertical
channel with a one-sided semicylindrical constriction with prescribed heat
flux. International Journal of Heat and
Fluid Flow 67: 155-167.
Roşca,
N.C. & Pop, I. 2013. Mixed convection stagnation point flow past a vertical
flat plate with a second order slip: Heat flux case. International Journal of Heat and Mass Transfer 65: 102-109.
Sajid,
M., Pop, I. & Hayat, T. 2010. Fully developed mixed convection flow of a
viscoelastic fluid between permeable parallel vertical plates. Computers & Mathematics with
Applications 59(1):
493-498.
Sharidan,
S., Amin, N. & Pop, I. 2005. G-jitter fully developed combined heat and
mass transfer by mixed convection flow in a vertical channel. International Communications in Heat and
Mass Transfer 32(5):
657-665.
Sivasamy,
A., Selladurai, V. & Rajesh Kanna, P. 2010. Mixed convection on jet
impingement cooling of a constant heat flux horizontal porous layer. International Journal of Thermal Sciences 49(7): 1238-1246.
*Corresponding
author; email: sharidan@utm.my
|